| 10:15p |
Вопрос по fancontrol
Имея ASUS X502C, на нём Ubuntu 15.10, хочу уметь вентилятор, и пытаюсь сформировать /etc/fancontrol:
________________________________________________________________________________________________
piyavking@koeuk:~$ sudo pwmconfig
# pwmconfig revision 6243 (2014-03-20)
This program will search your sensors for pulse width modulation (pwm)
controls, and test each one to see if it controls a fan on
your motherboard. Note that many motherboards do not have pwm
circuitry installed, even if your sensor chip supports pwm.
We will attempt to briefly stop each fan using the pwm controls.
The program will attempt to restore each fan to full speed
after testing. However, it is ** very important ** that you
physically verify that the fans have been to full speed
after the program has completed.
Found the following devices:
hwmon0 is acpitz
hwmon1 is coretemp
hwmon2 is asus
Found the following PWM controls:
hwmon2/pwm1 current value: 128
Giving the fans some time to reach full speed...
Found the following fan sensors:
hwmon2/fan1_input current speed: 0 ... skipping!
There are no working fan sensors, all readings are 0.
Make sure you have a 3-wire fan connected.
You may also need to increase the fan divisors.
See doc/fan-divisors for more information.
________________________________________________________________________________________________
конфиг не формируется, как я подозреваю, потому, что lm-sensors не определяет минимумальное и максимальное RPM для моего вентилятора (просто выдаёт текущее RPM, и всё):
________________________________________________________________________________________________
piyavking@koeuk:~$ sensors
acpitz-virtual-0
Adapter: Virtual device
temp1: +63.0°C (crit = +108.0°C)
coretemp-isa-0000
Adapter: ISA adapter
cpu: +63.0°C (high = +87.0°C, crit = +105.0°C)
cpu_core0: +65.0°C (high = +87.0°C, crit = +105.0°C)
cpu_core1: +62.0°C (high = +87.0°C, crit = +105.0°C)
asus-isa-0000
Adapter: ISA adapter
cpu_fan: 5500 RPM
temp1: +63.0°C
________________________________________________________________________________________________
Хочу отметить, что кулер поддаётся управлению командами вида
________________________________________________________________________________________________
sudo sh -c "echo 1 > /sys/class/hwmon/hwmon2/pwm1_enable"
sudo sh -c "echo 128 > /sys/class/hwmon/hwmon2/pwm1"
________________________________________________________________________________________________
Помогите, пожалуйста, рекомендациями.
sudo sensors-detect делал, fan divisors руками прописать в /etc/sensors.d/sensors.conf не смог (sensors ругается: 'Invalid keyword' ).
Спасибо за внимание. |